|
Parts Required. 500ml 'Cola' Bottle 80mm Steel Tube (Width of cigarette) Bottle Preparation Take the bottle and make a hole approximately a 1/3 of the way up. Make the hole big enough so that the tube will fit tightly in the hole, but loose enough to remove and refit. Fill the bottle up with water so that the level is just below the hole. Ingredient Preparation Finely crumble a small pile of resin onto a clean, dry surface. A Kitchen worktop or breadboard makes an ideal hard surface. Gun Loading Take your tube and push the end of a cigarette approximately 4mm into the tube. Cut with a 'Stanley' blade across the top of the tube so the cigarette is flush. Wet your finger and gently sweep across the top of the tube and cigarette. Now press the end of the tube (cigarette end) into the crumbled resin twice (for beginners!). Gently push the tube into the hole on the bottle. Be careful not to spill any water when doing this. Make sure that the bottom of the tube has enough clearance in the water for a 'bong' effect. Smoking Procedure Hold the bottle to your mouth at a dipped angle. With other and light a lighter and burn the resin layers slowly. Suck in very gently until resin is glowing and nearly burning through. Suck forcefully to clear all smoke from the bottle. Enjoy :o) |
|
How to Build a Shotgun |
|
|
